How to Create your own favorite iPod movie

• Introduction
• Step 1 :Download and install Apollo iPod Video Converter
• Step 2 :Run Apollo iPod Video Converter and make task list
• Step 3 :Customize output files
• Step 4 :Start conversion

Introduction

Want to create your own iPod movie? Try this software. Superb high quality! Very easy to use! Faster than ever! Just follow the instructions below, you can do that in a few clicks.
What you need:

• DVD drive.
• Apple iPod.

Step One: Download and install Apollo iPod Video Converter

Click here to download Apollo iPod Video Converter. After the download is finished, run exe file to install.

[back to top]

Step Two: Run Apollo iPod Video Converter and make task list

Run Apollo iPod Video Converter, and you will see the main screen appears like this:

Choose profile for out-put files:

Click on the drop-down column to open profile list:

Find the very profile for your iPod, video(mp4) or audio only(aac, m4a, mp3)

Load files and edit your task list

Here' re the buttons control the task list :

To add your conversion task(s); Tip:You can drag-and-drop the files into the list.

To remove selected task(s).

To clear the task list

and move a task up or down to decide conversion order.

[back to top]

Step Three: Customize output files

Customizing will be done in "Preview and Settings" window

Click the " " button at the right side of main window to open/close "Preview and Settings" window:

Buttons to control the preview window:

: Preview previous task

: Play selected task

: Pause preview

: Stop preview

: Preview next task

: Toggle to full screen preview

Tip:Play the file before any editing

 

Crop setting:

Click on to switch to crop setting

Play the video before you want to crop it.

Drag the cropping line or type in to decide the cropping area you want

Tip:you can also drag the whole cropping area to move it to a particular corner.

 

Period conversion:

Click on to switch to conversion period settings

Drag the small triangle at both ends or type in to set the length of output video and the start and end point of conversion.

Tip: you can also drag the blue bar to change the start and end point of conversion

 

Edit video information:

Click on to witch to video information editing

Type in the information as you wish

 

General Settings:

Click on button on the lower right corner of the main window and select "general settings":

Encoder preset: The balance of Speed and Quality of conversion (1:fastest speed;10:best quality).

Deinterlace video when converting: Check this option, when you convert a interlace video.

Shut down computer when job is done: Automatically shut down the computer for you.

 

[back to top]
   
 Step Four: Start conversion

 When everything is set, click on start button to begin conversion.

[back to top]